Application and Firing Instructions

APPLICATION INSTRUCTIONS:
1) Cut out desired decal.
2) Soak in room temperature or lukewarm water for 20 - 30 seconds. Don't force decals, when ready, decals will easily slide off backing paper.
3) Wet surface area of pottery where decal is going to be placed.  Place decal on surface of pottery and gently slide the backing paper from underneath the decal.
4) Now gently work the water and air out from under the decal with a squeegee or soft cloth. Be gentle, the decal is delicate at this point. Work from the center to the outer edges. Dry decal and surrounding area with paper towel or cloth.
5) Let dry for a minimum of 4-6 hours.

FIRING INSTRUCTIONS:
1) Inglaze decals need to reach the glost temperature where the glaze softens so the decal pigments can sink in. Basically, repeat the glaze cone fire or schedule for the decal fire. Example: If your glaze fire was to cone 04, your decal fire should be cone 04. The full firing range of these decals are 1742 - 2282 degrees Fahrenheit. Fire at medium or slow speed. It's always best to run some test pieces before running a kiln load.

TIPS:

1) These decals work best on white or light color glazes. Clear glazes may cause defects.

2)Decals are semi-transparent, glaze color will affect final result.

3) Our process is CMYK, there is no white toner. White in the design is from glaze color.

4) If you have very hard water you may want to consider using distilled water for soaking.

5)You can "piggyback" decal firings on low-fire glazes during standard cone 04 bisque fires. Or fire decals on mid-range glazes during a standard cone 6 glaze fire.

6) If you have worked with decals that have a cover coat (usually a yellow film on top of the sheet), be aware that these are a bit more delicate during application since there is no cover coat. The flux(ground glass) that makes the decal glossy is not in a cover coat, but built right into the ceramic toners. This is why our decals do not have a raised edge where the decal was cut out. 

7) If you have any questions, please reach out to us on Etsy messages or help@lunabellapottery.com